TM
The ECHO baby
TM
features warm, studio quality, delay up to 760ms with a "Dynamic Modulation Mode" If you hold the bypass switch for 2
seconds, this will put the ECHO baby TM
into Modulation Edit Mode. The LED will
blink to indicate this function.
Dynamic Modulation means the rate and depth are adjusted automatically as you
adjust the delay time. This improves the overall "feel" of the
modulation at all delay times. No more wild modulation at one setting,
and not enough at another. As you turn the delay time down, the
modulation speed is slightly increased, as is the depth. Once you find
the correct amount of modulation, you'll find that it sounds great on any
speed. No more adjusting delay time, then re-tweaking modulation with
Dynamic Modulation.
The Delay Time will remain what it was prior to changing
modes. Adjust the pot for the amount of modulation you want (between 9:00
and 12:00 are good settings). If you turn the pot all the way down, that
turns modulation off. To get out of Modulation Edit Mode hold the switch
again for 2 seconds. The Modulation Level will be saved and you will be
back to rate mode. If you unplug power, it will remember your modulation
setting. This is only true if you unplug it AFTER putting it back in
Delay Time mode. If you unplug it while in Modulation Edit Mode, it will
NOT save the Modulation, and will revert to the previous setting.